4/26/2021 0 Comments Agilent 34401A Pdf
The Protection Limit from HI to LO (Input terminals) is 1000 VDC or 750 VAC, which is also the maximum voltage measurement.Please check your inbox, and if you cant find it, check your spam folder to make sure it didnt end up there.However, upgrading the firmware may add or change product features.For the latest firmware and documentation, go to the product page at.
Agilent 34401A Manual And AnyFurther, to the maximum extent permitted by applicable law, Agilent disclaims all warranties, either express or implied, with regard to this manual and any information contained herein, including but not limited to the implied warranties of merchantability and fitness for a particular purpose. Agilent shall not be liable for errors or for incidental or consequential damages in connection with the furnishing, use, or performance of this document or of any information contained herein. Should Agilent and the user have a separate written agreement with warranty terms covering the material in this document that conflict with these terms, the warranty terms in the separate agreement shall control. Agilent 34401A License In SoftwareAgilent provides this customary commercial license in Software and technical data pursuant to FAR 12.211 (Technical Data) and 12.212 (Computer Software) and, for the Department of Defense, DFARS 252.227-7015 (Technical Data - Commercial Items) and DFARS 227.7202-3 (Rights in Commercial Computer Software or Computer Software Documentation). It calls attention to an operating procedure, practice, or the like that, if not correctly performed or adhered to, could result in damage to the product or loss of important data. Do not proceed beyond a CAUTION notice until the indicated conditions are fully understood and met. It calls attention to an operating procedure, practice, or the like that, if not correctly performed or adhered to, could result in personal injury or death. Do not proceed beyond a WARNING notice until the indicated conditions are fully understood and met. The protective features of this product may be impaired if it is used in a manner not specified in the operation instructions. Return the product to an Agilent Technologies Sales and Service Office for service and repair to ensure that safety features are maintained. The ground pin must be firmly connected to an electrical ground (safety ground) terminal at the power outlet. Any interruption of the protective (grounding) conductor or disconnection of the protective earth terminal will cause a potential shock hazard that could result in personal injury. Only qualified, service-trained personnel should remove the cover from the instrument. Switching while high voltages or currents are present may cause instrument damage and lead to the risk of electric shock. The HI and LO input terminals may be connected to mains in IEC Category II installations for line voltages up to 300 VAC. To avoid the danger of electric shock, do not connect the inputs to mains for line voltages above 300 VAC. See IEC Measurement Category II Overvoltage Protection on the following page for further information. To ensure safe operation of the instrument, do not exceed the Protection Limits shown on the front and rear panel, and defined as follows. Do not operate this switch while signals are present on the front or rear terminals. The HI and LO input terminals are used for voltage, resistance, frequency (period), and diode test measurements.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |